Adding Paper To Trays 3, 4, Or 5 - Xerox 6100BD - Phaser Color Laser Printer Manual

Adding Paper to Trays 3, 4, or 5

1. Press the Tray unlock button on the front of the tray. Wait for the red "Please wait" light to
go off.
NOTE: If the tray is not pulled out all of the way, the tray elevator will not go down as
paper is added.
2. When the green "Ready to open" light comes on, pull the tray out until it stops.
3. Move the rear and side guides away from the paper stack, as shown below.
4. Load the required paper into the paper tray. Load paper with the curl side facing down.
Load Xerox paper with the package wrapper seam side facing up.
NOTE: When loading drilled paper, be sure to fan the edge where the holes are located.
5. Position the stack against the front left corner of the tray, as shown below. This is
indicated by the green arrow on the bottom of the tray.
6. Move the rear and side guides until they touch the paper stack.
7. Close the tray slowly, but firmly, until it latches.
DT6180 HandyBook
Paper Trays & Loading Media
18