Fan The Paper, Turn The Paper Over, And Reload; If Paper Is Jammed In The Fuser, Release The Camming Motor Brake - Xerox 6100BD - Phaser Color Laser Printer Manual

Fan the Paper, Turn the Paper Over, and Reload

1. Open the paper tray you are using.
2. Remove the paper from the tray and lay it on a flat surface.
3. Place the palm of your hand on the centre of the stack of paper to hold it firmly.
4. Place the other hand at one corner of the stack and fan through the paper.
5. Repeat this procedure for each corner.
6. Discard the top and bottom sheet of paper.
7. Turn the paper over.
8. Reload the paper in the tray.
9. Make sure the edge guides touch the edge of stack.
10. Close the paper tray.
If Paper is Jammed in the Fuser, Release the Camming Motor
Brake
NOTE: There may be times when the Fuser Camming Motor Brake stalls due to a duplicator crash or
duplicator power failure. The Camming Motor Brake must be manually released.
To release the Camming Motor Brake manually:
1. Open the Processor Doors.
2. Grasp the green handle on the Fuser drawer and pull the drawer all the way out of the machine
until it stops.
WARNING: The Fuser rollers may be hot; reaching temperatures approximately 400 °F / 204
°C. Be very careful not to touch the Fuser rollers when performing this procedure.
3. On the bottom of the Camming Motor, all the way to the back of the Fuser drawer on the left side, is
the Camming Motor brake release. The brake release looks like a silver / gray square metal plate.
Reach under the motor and push up on the brake release.
4. Hold the brake release up until the Camming Motor mechanism stops. You will see the Fuser
rollers separate slightly.
DT6180 HandyBook
Solutions in Alphabetical Order
127