Xerox 6100BD - Phaser Color Laser Printer Manual page 126

10. Insert the plug into the slot on the measuring bracket. The measuring bracket is a black metal piece
on the right side of a very large gray metal block.
11. Feed the wire until the wire touches the back of the measuring bracket.
12. Insert the plug into the stitcher head until the plug snaps into place. Make sure the wire lines up
with the small hole in the Stitcher head.
13. Push the green Stitcher head wire release handle down and back.
14. Return the wire cutters to their original location next to Stitcher Spool B.
15. Lower the Stitcher panel. Ensure that the panel has been lowered all the way; otherwise the
Stacker will not deliver output.
16. Close the Finisher Doors.
DT6180 HandyBook
Solutions in Alphabetical Order
126