Xerox 6100BD - Phaser Color Laser Printer Manual page 81

5. Use a cotton swab to clean this mirror and the small plastic sensor to the right of the mirror. Make
sure you do not touch the hot surfaces in this area.
Cleaning the Q1009 Sensor:
6. To the left of Paper Tray 1, at the back of the Fuser Module, locate the area 7 label on the machine
frame.
7. Look inside the cutout area. You may need to kneel down so you can see inside the cutout. To your
left is a clear plastic bottle containing Fuser Agent. Inside the cutout, and coming out on the side of
the plastic bottle, is a shiny metal tab. The right surface near the top of that tab is a mirror. About
10 mm (3/8 of an inch) to the right, facing the mirror, is the Q1009 sensor.
8. Clean the mirror and sensor with a small amount of Lens and Mirror Cleaner on a soft, lint-free
cloth.
9. Push the Fuser Module firmly back into the machine.
10. Close the Processor Doors.
DT6180 HandyBook
Solutions in Alphabetical Order
81