Clean The Registration Transport Sensor (Q861) - Xerox 6100BD - Phaser Color Laser Printer Manual

6. Clean the sensor with a small amount of Lens and Mirror Cleaner on a soft, lint-free cloth.
7. Push the Fuser Module firmly back into the machine.
8. Close the Processor Doors.

Clean the Registration Transport Sensor (Q861)

The Q861 Sensor is located in area 4, behind the area 4 green handle.
1. Open the Processor Door. The handle to open the door is above and to the left of Paper Tray 1.
2. Locate the area 4 green handle which is approximately 72 mm (2 inches) directly below the left side
of Tray 2.
3. Raise the green handle and the baffle that is attached, until it locks into place.
4. Locate the Q861 Sensor under the baffle. The sensor is in the front left corner and approximately
76 mm (3 inches) back from the handle.
CAUTION: To avoid damage to the machine, do not use any liquids or solvents of any kind
to clean the Q861 Sensor.
5. Gently rub a dry cleaning pad against the underside of the sensor, as illustrated, and move it left to
right to clean the sensor.
DT6180 HandyBook
Solutions in Alphabetical Order
85