Clear The Entire Paper Path From The Paper Trays To The Finisher; Clear The Fault In The Printer Fault Clearance Window - Xerox 6100BD - Phaser Color Laser Printer Manual

9. Locate the handle on the left side of the Binder and pull it up quickly to snip off the tape that you
advanced. Press the green handle down.
10. Push the Binder into the Finisher until it latches.
11. Close the Finisher Doors.
12. Close the Finisher Top Cover.

Clear the Entire Paper Path From the Paper Trays to the Finisher

You should inspect the entire paper path from the paper trays to the Finisher to make sure there are no
paper jams in any of the areas. Make sure to look for small pieces of paper that may have torn off during
previous attempts to clear jams.

Clear the Fault in the Printer Fault Clearance Window

Clearing a fault using DocuSP software version 3.x or above:
1. From the DocuSP for DocuTech 2000 Series 61xx (or your printer model) window, select the fault
from the Fault List that you want to clear. The Fault List is located in the upper right corner just
below the word System. The Printer Fault Clearance window will be displayed for the fault you
selected.
2. Follow the given clearance instructions in the Printer Fault Clearance window.
NOTE: You can select [Close] to close the Printer Fault window without clearing the fault. However,
the fault will remain until it is reset through the Printer Fault Clearance window.
3. Select [Close] when you have completed your work in the Printer Faults Clearance window.
Clearing a fault using DocuSP software version 2.x or below:
1. From the DocuSP Print Services window, there will be an icon with a picture of a wrench and a red
lightning bolt displayed, if there is a fault.
2. Select the [Wrench] icon to open the Printer Faults window.
3. In the Printer Fault window, select the fault to display the instructions for clearance.
4. Follow the given clearance instructions in the Printer Fault Clearance window.
DT6180 HandyBook
Solutions in Alphabetical Order
102