Adjust The Binder Tape Registration - Xerox 6100BD - Phaser Color Laser Printer Manual

Adjust the Binder Tape Registration

NOTE: Adjusting the top edge of the Binder Tape changes the positioning of the tape. Adjusting
the bottom of the Binder Tape changes the length of the tape.
To adjust the Binder Tape registration:
1. Make sure that the tape guides are clean and free of glue residue. The tape guides are
on the top of the Binder.
2. Measure the adjustment amount for the top edge of a finished book. If the tape is
overhanging on the top or bottom, and not covering the bottom or top, then the tape
position needs to be adjusted.
3. Open the Finisher Doors.
4. Locate the black Binder tape knob on the front of the Binder Drawer; just to the right of
Paper Tray 3. You should see the Binder tape coming out from the bottom and wrapping
around the feeder back into the Finisher.
The knob is spring loaded and moves in increments to change the location of the Binder
tape. Each increment equals a change of 0.1 mm, up or down, on the edge of the book.
One full rotation of the knob is equal to 1 mm (0.04 inch).
5. Pull the knob toward you to rotate it for the adjustment.
6. Adjust the tape position by performing one of the following steps:
•
Pull the knob and rotate it to the right to move the tape toward the top edge of the
book, or
•
Pull the knob and rotate it the left to move the tape toward the bottom edge of the
DT6180 HandyBook
Machine Maintenance
46