Xerox 6100BD - Phaser Color Laser Printer Manual page 35

6. Remove the tape reel.
7. Slide the new tape reel onto the tape reel drive. Make sure that the larger hole in the
center of the tape reel faces the tape reel drive.
8. If necessary, rotate the tape reel slightly until it clicks into position.
9. Move the reel retainer to the vertical, or locked position.
NOTE: Tape feed problems can result if the reel retainer is not in the locked position.
10. Thread the tape around the spools following the instructions on the Binder tape loading
label which is located to the left of the Binder tape reel.
11. Thread the tape around the drive roll to the edge of the pressure roll.
NOTE: Make sure the tape is threaded correctly. As it comes off the reel and over the
first pulley, it must go through the sensor. If the tape is not threaded correctly, the
message will not go away.
12. Turn the green knob to the right until the tape is at least 51 mm (2 inches) beyond the
tape guides.
DT6180 HandyBook
Replacing Consumables
35