Program Image Shift For A Job; Program Paper Tray 5 As A Non-Fusing Tray - Xerox 6100BD - Phaser Color Laser Printer Manual

Program Image Shift for a Job

To program Image Shift for a job with DocuSP software version 3.x:
1. From the DocuSP for DocuSP 2000 Series 61xx window, select [Job Manager]. The Job
Manager window is displayed.
2. Click to select the job. The job will be highlighted.
3. Right-click and select [Properties]. The Job Properties for job window is displayed.
4. Select the [Image Shift] tab.
5. Click the [Up] and [Down} arrows in the X and Y fields to program the shift(s) (for side 1
and 2,) of the job. You can also type the shift amount in the field using the keyboard.
6. In the lower right there are addition Shift Options including Independent, Mirror, Mirror X
only, Mirror Y only, Tandem, Tandem X only, and Tandem Y only.
7. Select [Ok] to save changes.
To program Image Shift for a job with DocuSP software version 2.x:
1. From the DocuSP Print Services window, select [Job Manager]. The All Queues: All Jobs
window is displayed.
2. Click to select the job. The job will be highlighted.
3. Right-click and select [Properties]. The Job Properties for job window is displayed.
4. Select the [Image Shift] tab.
5. Click the [Up] and [Down} arrows in the X and Y fields to program the shift(s) (for side 1
and 2,) of the job.
6. Select [Ok] to save changes.

Program Paper Tray 5 as a Non-Fusing Tray

NOTE: Paper Tray 4 is by default the non-fusing tray; however, if you already have stock in
Paper Tray 4 and need to run another stock out of Paper Tray 5 you can use this procedure.
To program Paper Tray 5 using DocuSP software version 3.x:
1. In the DocuSP for DocuTech 2000 Series 61xx window, select [Printer Manager].
2. Select the [Paper Tray] tab.
3. Right-click on [Tray 5]. A menu will be displayed.
4. Select [Properties] from the menu.
5. In the lower left corner of the Tray 5 Properties window under Options, click on the
[Fuser] box to remove the check mark.
6. Select [OK]. The Route column on the far right should now display 'Non Fuser' for Tray 5.
To program Paper Tray 5 using DocuSP software version 2.x or below:
1. In the DocuSP Print Services window, select [Printer Manager]. The Printer Manager
window will be displayed.
2. Select [Tray 5].
3. Select [Trays] from the toolbar. A menu will be displayed.
4. Select [Paper Stock] from the menu.
5. At the top of the window, next to the word Route, select [Non-Fuser]. The button will turn
red for your selection, or remain gray when not selected.
6. Select [Ok].
DT6180 HandyBook
Programming Features
156