Mac Access-List Extended - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per IP ACL is hardware dependent.
• If you configure an IP ACL on an interface, you cannot configure a MAC ACL on the
same interface.

13.7.1 mac access-list extended

This command creates a MAC Access Control List (ACL) identified by
consisting of classification fields defined for the Layer 2 header of an Ethernet frame. The
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
<name>
identifying the MAC access list.
If a MAC ACL by this name already exists, this command enters Mac-Access-List config
mode to allow updating the existing MAC ACL.
Note: The CLI mode changes to Mac-Access-List Config mode when you
Format
Mode
13.7.1.1 no mac access-list extended
This command deletes a MAC ACL identified by
Format
Mode
13-32
successfully execute this command.
mac access-list extended <name>
Global Config
no mac access-list extended <name>
Global Config
v1.0, November 2007
from the system.
<name>
Quality of Service (QoS) Commands
,
<name>