NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual page 267

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
Admin Mode
Interfaces
Enabled for IGMP
Snooping
Multicast Control
Frame Count
VLANS Enabled
for IGMP
Snooping
When you specify the
IGMP Snooping
Admin Mode
Fast Leave Mode
Group
Membership
Interval
Max Response
Time
Multicast Router
Present Expiration
Time
IGMP Snooping Commands
This indicates whether or not IGMP Snooping is active on the
switch.
This is the list of interfaces on which IGMP Snooping is
enabled.
This displays the number of multicast control frames that are
processed by the CPU.
This is the list of VLANS on which IGMP Snooping is
enabled.
> values, the following information appears:
<slot/port
This indicates whether IGMP Snooping is active on the inter-
face.
Indicates whether IGMP Snooping Fast-leave is active on
the VLAN.
Shows the amount of time in seconds that a switch will wait
for a report from a particular group on a particular interface,
which is participating in the VLAN, before deleting the inter-
face from the entry.This value may be configured
Displays the amount of time the switch waits after it sends a
query on an interface, participating in the VLAN, because it
did not receive a report for a particular group on that inter-
face. This value may be configured.
Displays the amount of time to wait before removing an
interface that is participating in the VLAN from the list of
interfaces with multicast routers attached. The interface is
removed if a query is not received. This value may be config-
ured.
v1.0, November 2007
15-7