NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual page 236

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
You can specify the Ethertype value as either a keyword or a four-digit hexadecimal value
from 0x0600-0xFFFF. The currently supported
arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of
these translates into its equivalent Ethertype value(s), as shown in
Table 13-1. Ethertype Keyword and 4-digit Hexadecimal Value
Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipv6
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first
(or outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for
handling traffic that matches this rule. The allowed
is the number of user configurable queues available for the hardware platform. The assign-
queueparameters are only valid for a 'permit' rule.
Note: The special command form
Format
Mode
13-34
Corresponding Value
0x809B
0x0806
0x80D5
0x0800
0x86DD
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
Ethernet layer 2 packets, and is the equivalent of the IP access list "match
every" rule.
{deny|permit} {{<srcmac> <srcmacmask>} | any}
{{<dstmac> <dstmacmask>} | any}
[<ethertypekey> | <0x0600-0xFFFF>]
[vlan {eq <0-4095>}] [cos <0-7>]
[[log] [assign-queue <queue-id>]]
Mac-Access-List Config
v1.0, November 2007
<ethertypekey>
<queue-id>
{deny|permit} any any
Quality of Service (QoS) Commands
values are: appletalk,
Table 13-1.
value is 0-(n-1), where n
is used to match all