Network Parms (Parameter); Network Mgmt_Vlan; Network Protocol - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

3.1.2 network parms (parameter)

This command sets the IP Address, subnet mask and gateway of the device. The IP
Address and the gateway must be on the same subnet.
Format
Mode

3.1.3 network mgmt_vlan

This command configures the Management VLAN ID.
Default
Format
Mode
3.1.3.1 no network mgmt_vlan
This command sets the Management VLAN ID to the default.
Format
Mode

3.1.4 network protocol

This command specifies the network configuration protocol to be used. If you modify this
value, change is effective immediately. If you modify this value, the change is effective
immediately. If you use the
BootP server until a response is received. If you use the
periodically sends requests to a DHCP server until a response is received. If you use the
parameter, you must configure the network information for the switch manually.
none
Default
Format
Mode
3-2
network (parms | parameter) <ipaddr> <netmask>
[<gateway>]
Privileged EXEC
1
network mgmt_vlan <1-4069>
Privileged EXEC
no network mgmt_vlan
Privileged EXEC
parameter, the switch periodically sends requests to a
bootp
none
network protocol {none | bootp | dhcp}
Privileged EXEC
v1.0, November 2007
parameter, the switch
dhcp
Administrative Access Commands