Match Ip Dscp; Match Ip Precedence - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Layer-2 switches with static routing, software version 7.0
Hide thumbs Also See for GSM7224R - ProSafe Switch:
Table of Contents

Advertisement

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

13.3.10 match ip dscp

This command adds to the specified class definition a match condition based on the value
of the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order
six bits of the Service Type octet in the IP header (the low-order two bits are not checked).
The
<dscpval>
through one of the following keywords:
af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative
Format
Mode

13.3.11 match ip precedence

This command adds to the specified class definition a match condition based on the value
of the IP Precedence field in a packet, which is defined as the high-order three bits of the
Service Type octet in the IP header (the low-order five bits are not checked). The
precedence value is an integer from 0 to 7.
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative
Format
Mode
13-14
value is specified as either an integer from 0 to 63, or symbolically
ways to specify a match criterion for the same Service Type field in the IP
header, but with a slightly different user notation.
match ip dscp <dscpval>
Class-Map Config
ways to specify a match criterion for the same Service Type field in the IP
header, but with a slightly different user notation.
match ip precedence <0-7>
Class-Map Config
v1.0, November 2007
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,
.
Quality of Service (QoS) Commands

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gsm7248r - prosafe switchProsafe 7200r series

Table of Contents