Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
Acceptable values are:
100h
100f
10h
10f
4.1.12 speed all
This command sets the speed and duplex setting for all interfaces.
Format
Mode
Acceptable values are:
100h
100f
10h
10f
4.1.13 monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). To enable port monitoring, you must add a source interface, destination
interface, and enable the mode. If enabled, the probe port monitors all the traffic received
and transmitted on the physical monitored port.
Format
Mode
4-6
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
speed all {<100 | 10> <half-duplex | full-duplex>}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
monitor session <session-id> {source interface
<slot/port> | destination interface <slot/port> |
mode}
Global Config
v1.0, November 2007
Port and System Setup Commands