Creating Program - Brother BAS-311E Instruction Manual

Chapter 3 Programming with Command Function
122

Creating program

Creating a line. Input the stitch length in
LI
Creating a circle by specifying 3 points. Input the overlap stitch
2 0 LI
counts in
Creating a circle in the clockwise direction. Input the overlap stitch
2 1 LI
counts in
Creating a circle in the counterclockwise direction. Input the
2 2 LI
overlap stitch counts in
Creating a circle in the clockwise direction. Input the overlap stitch
2 3 LI
counts in
Creating a circle in the counterclockwise direction. Input the
2 4 LI
overlap stitch counts in
Creating an arc by specifying 3 points
3 0 0 LI LI
Creating a semicircle in the clockwise direction
3 1 0 LI
Creating a semicircle in the counterclockwise direction
3 2 0 LI
Creating a curve. Input a stitch pitch in
M
complete the curve data.
Creating a double stitch in the reverse direction to the sewing
2 M
path. Input the width of double stitch in
Creating an parallel stitch in the same direction to the sewing
3 M
path. Input the width of parallel stitch in
Creating an offset. Input the width for offset in
4 M
Starting a multiple stitch.
5 0 0 M
Creating a multiple stitch. Input the number of lines for a multiple
5 M
stitch in
Creating a zigzag stitch. Input the width of zigzag in
7 M
input the pitch of zigzag stitch by pressing
Inputting data (x2)
9 0 2 M
Inputting data (x5)
9 0 5 M
Inputting data (x10)
9 1 0 M
Stopping the needle at the upper end by split
2 2 0 L
Stopping the needle at the lower end by split
2 2 1 L
Carrying out zigzag stitch on the right side to the sewing path
8 7 L
7
Carrying out zigzag stitch on the left side to the sewing path
7 8 8 L
Carrying out double stitch on the right side to the sewing path
Carrying out parallel stitch on the right side to the sewing path
Carrying out offset on the right side to the sewing path
.
.
.
.
.
.
Programmer
.
. Input 7 8 9 L to
.
.
.
, and
.
M