Symmetrical Pattern - Brother BAS-311E Instruction Manual

Chapter 3 Programming with Command Function
Inputting the end code
1. Press
L
1 1 1 E
The work clamp returns to the start position.
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
Ending program
1. Press .
P

Symmetrical pattern

The following symmetrical pattern types are available:
134
at the last stitch and press
.
Symmetric to Y axis
Use command
4 4
Symmetric to point
Use command
4
4
A pattern symmetric to the X axis or the Y axis is
programmed. After programming the pattern, select
the symmetrical pattern type to complete the pattern.
The example in the left is used for explanation of
programming symmetric to the Y axis.
.
2 L
.
0 L
Programmer
Symmetric to X axis
Use command
4 4
Turnover
Use command
4
4
.
1 L
.
3 L