Brother BAS-311E Instruction Manual page 51

Chapter 2 Programming with Help Function
2. Select with
3. Move the work clamp with
when the needle point is at point q of
the pattern.
The first stitch (point q) is programmed.
4. Select with
5. Input the stitch length and the number of
lines for a multiple stitch. Press
"2.0 mm" is input for a stitch length in the example.
Input "030" to make the stitch length to 3.0 mm.
To switch input between the stitch length and the number of
lines, use
6. Move the work clamp with
when the needle point is at point w of
the pattern.
7. Move the work clamp with
twice when the needle point is at point e
of the pattern.
Be sure to press
a split is not made, the corner will be round.
8. Program the following points up to point ! 7
with the curve programming steps.
When there is a liner section, move the needle point from the
split to the next split, and press
In the example, a linear line is programmed between points u
and o. Be sure to program a linear line also for the matched
section between points @4 and @6 .
By pressing
0
point. It cannot be returned beyond the previous split.
By pressing
1
split. However, when the needle point is at a split, it cannot be
moved.
By pressing
2
before the previous split.
9. Press .
F
. Press
is at point !8 of the pattern.
50
and press
and press
.
twice for a split at a corner like point e. If
twice.
, the needle point is returned to the previous
, the needle point is returned to the previous
, the needle point is returned to the split
Move the work clamp with
when the needle point
.
. Press
.
.
. Press
. Press
Programmer