Chapter 5 Reading/Writing Data
Reading data
Reads data from a floppy disk.
When there is no data for creation, data can be read by pressing by pressing the R/W button
on the operation panel.
This operation cannot be available in command mode.
Data created in BAS-300 and BAS-300A series can also be read.
1.
2.
3.
210
Select
and press
Make sure that
is selected, and press
Input the number of program with a numeric key.
If there is data,
appears.
If there is no data,
appears. If
.
appears, the data is from BAS-300 or BAS-300A series.
Programmer
.