Brother BAS-311E Instruction Manual page 48

4. Select with
5. Select with
6. Input the zigzag width and the stitch length
and press .
3.0 mm is input in the example.
Input 030 to make the width and the stitch length to 3.0 mm.
To switch input between the stitch length and the width, use
.
7. Move the work clamp with
when the needle point is at point B of the
pattern.
To program curves, repeat this step.
8. Press again.
9. Press three times.
ESC ESC
Inputting the end code
1. Select with
2. Select the end code type with
press .
"111" is selected in the example. Press
returns to the first stitch(point A).
3. Press .
ESC ESC
The work clamp returns to the home position.
and press .
and press .
. Press
and press .
and
and the work clamp
Programmer
Chapter 2 Programming with Help Function
47