Brother BAS-311E Instruction Manual page 136

Programming
1. Press .
P
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with
when the needle point is at point A of the
L
pattern.
The first stitch (point A) is programmed.
3. Create the program to point B.
4. Input point B and press
Input the command symmetric to Y axis.
5. The needle point moves slowly from point B
to point A in the right half and it is
automatically programmed. Press
make fast movement.
Inputting the end code
1. Press
1 1 1
point A.
The work clamp returns to the start position.
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
Ending program
1. Press .
P
4 2 L
4
when needle stops at
E
Programmer
Chaprter 3 Programming with Command Function
. Press
.
to
135