Brother BAS-311E Instruction Manual page 130

3. Input the stitch length and press
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Move the work clamp with
when the needle point is at point B of the
L
pattern.
5. Move the work clamp with
when the needle point is at point
7 8 9 L
C of the pattern.
Point C becomes a sharp corner. The range from points A to C
is programmed.
6. Press .
M
To change the stitch length, specify the pitch value before
pressing .
M
7. Move the work clamp with
when the needle point is at point D of the
L
pattern.
8. Repeat step 7 and create the program to
point E.
9. Press
7 8 9
The range from points C to E is programmed.
10. Create the program to point I in the similar
manner.
Inputting the end code
1. Press
1 1
1
The work clamp returns to the start position.
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
M
as in step 5.
L
.
E
Programmer
Chaprter 3 Programming with Command Function
.
. Press
. Press
. Press
129