Support Info; Refresh Rate; Privacy Settings; Select Language - HP Jetdirect J7974E Administrator's Manual

printer—either from the server or from a client computer that has set up that printer—will include a reset
command at the beginning of the job.

Support Info

Use this page to configure links for Support assistance. You can designate a Support person and phone
number of an administrator for this device, as well as URL addresses for Web-based product and
technical support.

Refresh Rate

The refresh rate is the time period (in seconds) that the diagnostic pages will be automatically updated.
The value '0' disables the refresh rate.

Privacy Settings

On the Privacy Settings page, you can allow the embedded Web server to collect product identification
and use information and then send the information to HP (Internet access is required). Product use
information assists HP in improving product features and services. The default setting for this page will
depend on the user's selection on initial access to the Networking tab.
To enable this feature, check the checkbox and click Apply.
To disable this feature, clear the checkbox and click Apply.

Select Language

This link appears if the HP Jetdirect Web pages support multiple languages. Supported languages may
also be selected through language preference settings in your browser (see your browser's Help).
To display supported non-English languages, the use of cookies must be enabled in your browser
settings.

Security: Settings

In the SECURITY section, the Settings menu provides access to the following tabs: Status (default),
Wizard, Restore Defaults. The available settings depend on your particular print server model.

Status

The Status page displays the current security configuration settings of the print server. The settings
that will be displayed depend on the features supported by the print server.

Wizard

NOTE
Instead, use HP Web Jetadmin to configure your network security settings to ensure they are
properly set for your network.
Select the Wizard tab to open the initial Wizard page. If prompted with security alerts, click Yes to
proceed.
The Wizard page identifies the current security level that was last configured on the print server. If a
security level has not been configured, the security level will be None. However, if HTTPS is required
for access to the networking pages, then the default setting will indicate Custom.
ENWW
If you use HP Web Jetadmin to manage your devices, you should not use this wizard.
Networking Tab 81