Mid-Mounting The 1125 Appliance On A Two-Post Rack; Attaching Brackets To The Chassis; Attaching L Brackets To Center Posts - Cisco Physical Access 1125 Appliance User Manual

Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-2
1
Table 3-3
Table 3-3
Callout
1
2
3
4
5
6

Mid-Mounting the 1125 Appliance on a Two-Post Rack

This section contains the following topics:
•
•
•

Attaching Brackets to the Chassis

Before you begin, check the #10-32 x ½-inch screws that are included in the Fastener Pack to see if they
are the correct size for your rack. If not, obtain the correct screws to use in the procedure where "rack
screws" are required.
To attach brackets to the chassis, perform the following procedure:
Step 1 Remove the chassis handles by removing the two screws (see
Then, replace the screws to keep the bezel attached to the appliance.
Cisco Physical Access 1125 Appliance User Guide
3-4
Fastener Pack Contents
2 3 4
describes the fasteners that are shown in
Fastener Pack Contents
Hardware Description
Screw, #10-32 x ½-inch (rack screw)
Screw, hex head
Screw, #10-32 x 7/8-inch
Handle spacers (not used)
Nut bar (not used)
Chassis disks (not used)
Attaching Brackets to the Chassis, page 3-4
Attaching L Brackets to Center Posts, page 3-6
Installing the Chassis in the Rack, page 3-7
Chapter 3
5 6
Figure 3-2.
Rack Mounting the Cisco PAM 1125 Appliance
Quantity
8
4
2
2
4
2
Figure 3-3 on page 3-5) from each handle.
OL-20929-01