Appendix; Unsupported Commands In Cisco Ios Release 12.2(40)Se; Access Control Lists; Unsupported Privileged Exec Commands - Cisco WS-C2960-24LC-S Software Configuration Manual

Unsupported Commands in
Cisco IOS Release 12.2(40)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2960 switch prompt but are not supported in this release, either because
they are not tested or because of Catalyst 2960 switch hardware limitations. This is not a complete list.
The unsupported commands are listed by software feature and command mode.

Access Control Lists

Unsupported Privileged EXEC Commands

access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
show accounting
show ip accounting [checkpoint] [output-packets | access violations]
show ip cache [prefix-mask] [type number]

Unsupported Global Configuration Commands

access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended

Unsupported Route-Map Configuration Commands

match ip address prefix-list prefix-list-name [prefix-list-name...]
OL-8603-04
A P P E N D I X
Catalyst 2960 Switch Software Configuration Guide
D
D-1