Verifying The Running Configuration Settings; Show Running Config Command Example - Cisco 12406 Installation And Configuration Manual

Configuration Changes

Verifying the Running Configuration Settings

show running Config Command Example

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-62
BOOTFLASH: GS Software (GSR-BOOT-M), Version 11.2(18)GS4, EARLY
DEPLOYMENT RELE
Getty uptime is 22 hours, 15 minutes
System returned to ROM by reload
System image file is "tftp://xxx.xx.xx.xxx/directory/name/gsr-p-mz"
cisco 12406/GRP (R5000) processor (revision 0x05) with 262144K bytes
of memory.
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
Last reset from power-on
1 Route Processor Card
.
.
.
Configuration register is 0x0
.
.
.
router#
To check the running configuration settings or any changes made to settings
before you save them, enter the show running-config command at the privileged
EXEC mode prompt. For a Quad OC-3c/STM-1c POS interface installed in slot 1,
the show running-config command typically displays output in the form shown
in the example below. Depending on the image version of the Cisco IOS software
running on your router and the way it is equipped, the results of your show
running-config command might be different.
router# show running-config
Building configuration...
Current configuration:
!
version 12.0
no service pad
no service udp-small-servers
Chapter 3 Installing the Router
OL-11497-03