Configuring The Dual-Rate Line Cards - Cisco ASR 9000 Series Installation Manual

Configuring the Dual-Rate Line Cards

7.
8.
9.
10.
11.
Configuring the Dual-Rate Line Cards
Note
Oversubscription will be supported on these line cards in a future release of IOS XR 6.2.x train.
The 24-port and 48-port dual-rate line cards support GE and 10GE speeds.
Note
See 24-Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP and 48-Port 10-Gigabit
Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP sections in the Cisco ASR 9000 Series Aggregation
Services Router Ethernet Line Card Installation Guide for information on the line cards.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
142
If you want to disable the Cisco Discovery Protocol (CDP), which is not required, use this command:
RP/0/RSP0/CPU0:router(config-if)# no cdp
Add any other configuration subcommands required to enable routing protocols and adjust the interface
characteristics. Examples of such subcommands are:
RP/0/RSP0/CPU0:router(config-if)# flow-control ingress
RP/0/RSP0/CPU0:router(config-if)# mtu 1448
RP/0/RSP0/CPU0:router(config-if)# mac-address 0001.2468.ABCD
When you have included all the configuration subcommands to complete the configuration, enter the
commit command to commit all changes you made to the running configuration.
RP/0/RSP0/CPU0:router(config-if)# commit
Enter Ctrl-Z to exit configuration mode. If you did not enter the commit command, you will be prompted
to do so:
RP/0/RSP0/CPU0:router(config-if)#
Uncommitted changes found, commit them before exiting(yes/no/cancel)? [cancel]:
Answer yes to commit, no to exit without a commit, or cancel to cancel the exit (default).
Write the new configuration to memory:
RP/0/RSP0/CPU0:router# copy run
disk0:/config/running/alternate_cfg:/
router.cfg
Destination file name (control-c to abort): [/router.cfg]?
The destination file already exists. Do you want to overwrite? [no]: yes
Building configuration.
223 lines built in 1 second
[OK]
The system displays an OK message when the configuration has been stored.
Verifying and Troubleshooting the Line Card Installation