Table of Contents
Advertisement
Chapter 3
Installing Components
Note
Caution
Step 10
Click Next. The Shared Secret Password screen appears.
Enter and confirm the shared secret password.
Step 11
Note
Click Next. The Installation Parameters screen appears. This screen identifies the values that you have
Step 12
entered in the previous screens. To modify any of the values entered:
a.
b.
c.
Click Next. When the installation is complete, the Installation Summary screen appears. Click Finish to
Step 13
exit the installation program.
You must configure your license keys using the administrator's user interface. Refer to the Cisco
Note
Broadband Access Center for Cable Administrator's Guide for additional information.
Installing Extensions on a Network Registrar Server
You install BACC extensions on a Network Registrar server. If you are deploying BACC in a failover
environment, you also must install the extensions on the failover servers. After you install extensions,
you need to configure them.
The remainder of this section explains how to install, configure, and validate these extensions.
OL-19105-01
The installation program obtains the IP address of the RDU automatically. You do not need to
enter this value.
If you change the default listening port value, ensure that the new value does not conflict with
any existing port assignments. Also, ensure that you configure all DPEs and Network
Registrar servers with the correct RDU port number. See the Broadband Provisioning
Registrar Administrator's Guide for information about configuring the DPE and Network
Registrar extensions.
The RDU, DPEs, and Network Registrar extension points all use the same shared secret. This is
a character string, or token, that is used to authenticate communication.
Click Back until the desired screen appears.
Make the necessary changes.
Click Next repeatedly until you return to this screen.
Installing Components Using the Graphical User Interface
Cisco Broadband Access Center for Cable Installation Guide 2.7
3-3
Advertisement
Table of Contents
