HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING User Manual page 177

Column Meaning
BLOCK Block number in which the TOOL CALL block
was programmed
PATH TOKEN = TOOL: Path name of the active main
program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
OVRMAX Maximum feed rate override that occurred
during machining. During test run, the TNC
enters the value 100 (%)
Minimum feed rate override that occurred
OVRMIN
during machining. During test run, the TNC
enters the value -1
NAMEPROG 0: The tool number is programmed
1: The tool name is programmed
There are two ways to run a tool usage test for a pallet file:
The highlight is on a pallet entry in the pallet file:
The TNC runs the tool usage test for the entire pallet.
The highlight is on a program entry in the pallet file:
The TNC runs the tool usage test for the selected program.
HEIDENHAIN iTNC 530 177