Cisco 7941G - Unified IP Phone VoIP Administration Manual page 96

Configuring Security on the Cisco Unified IP Phone
Note
Scroll to LSC and press the Update softkey.
Step 4
The phone prompts for an authentication string.
Enter the authentication code and press the Submit softkey.
Step 5
The phone begins to install, update, or remove the LSC, depending on how the
CAPF was configured. During the procedure, a series of messages displays in the
LSC option field in the Security Configuration menu, so you can monitor
progress. When the procedure completes successfully, the phone will display
Installed or Not Installed.
The LSC install, update, or removal process can take a long time to complete. You
can stop the process at any time by pressing the Stop softkey from the Security
Configuration menu. (Settings must be unlocked before you can press this
softkey.)
When the phone successfully completes the installation procedure, it displays
"Success." If the phone displays, "Failure," the authorization string may be
incorrect or the phone may not be enabled for upgrading. Refer to error messages
generated on the CAPF server and take appropriate actions.
You can verify that an LSC is installed on the phone by choosing Settings >
Model Information and ensuring that the LSC setting shows Yes.
Related Topic
•
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
3-20
If a Settings Menu password has been provisioned, SIP phones present an
"Enter password" prompt after you enter **#.
Understanding Security Features for Cisco Unified IP Phones, page 1-13
Chapter 3 Setting Up the Cisco Unified IP Phone
OL-14620-01