Cisco 7941G - Unified IP Phone VoIP Administration Manual page 95

Chapter 3 Setting Up the Cisco Unified IP Phone
Alternatively, you can initiate the installation of an LSC from the Security
Configuration menu on the phone. This menu also lets you update or remove an
LSC.
Before You Begin
Make sure that the appropriate Cisco Unified Communications Manager and the
Certificate Authority Proxy Function (CAPF) security configurations are
complete:
•
•
•
•
Refer to Cisco Unified Communications Manager Security Guide for more
information.
To configure an LSC on the phone, perform these steps.
Procedure
Obtain the CAPF authentication code that was set when the CAPF was
Step 1
configured.
Step 2 From the phone, choose Settings > Security Configuration.
Note
Press **# to unlock settings on the Security Configuration menu.(See the
Step 3
"Unlocking and Locking Options" section on page 4-3
locking and unlocking options.)
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
The CTL file should have a CAPF certificate.
The CAPF certificate must exist in the /usr/local/cm/.security/certs folder in
every server in the cluster.
The CAPF is running and configured.
The phone should have the correct load file. To verify the image, choose
Settings > Status > Firmware Versions. The application load file should
begin with P00307.
You can control access to the Settings Menu by using the Settings Access
field in the Cisco Unified Communications Manager Administration
Phone Configuration window. For more information, see the Cisco
Unified Communications Manager Administration Guide.
Configuring Security on the Cisco Unified IP Phone
for information using
3-19