Cisco 7941G - Unified IP Phone VoIP Administration Manual page 195

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Table 7-2 Status Messages on the Cisco Unified IP Phone
Message
BootP server used
CFG file not found
CFG TFTP Size Error The configuration file is too
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
Description
The phone obtained its IP
address from a BootP server
rather than a DHCP server.
The name-based and default
configuration file was not
found on the TFTP Server.
large for file system on the
phone.
Possible Explanation and Action
None. This message is informational only.
The configuration file for a phone is created
when the phone is added to the Cisco
Unified Communications Manager database.
If the phone has not been added to the Cisco
Unified Communications Manager database,
the TFTP server generates a
response.
Found
Phone is not registered with Cisco
•
Unified Communications Manager.
You must manually add the phone to
Cisco Unified Communications Manager
if you are not allowing phones to
auto-register. See the
with Cisco Unified Communications
Manager Administration" section on
page 2-17 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
If you are using static IP addresses, check
•
configuration of the TFTP server. See the
"Network Configuration Menu" section
on page 4-7 for details on assigning a
TFTP server.
Power cycle the phone.
Status Menu
CFG File Not
"Adding Phones
7-5