Cisco 7941G - Unified IP Phone VoIP Administration Manual page 140

Device Configuration Menu
Table 4-14 Network Configuration Menu Options (continued)
Option Description
CDP: SW Port Indicates whether CDP is enabled on the switch
port (default is enabled).
•
•
Note
Note
LLDP: PC Port Enables and disables Link Layer Discovery
Protocol (LLDP) on the PC port. Use this setting
to force the phone to use a specific discovery
protocol, which should match the protocol
supported by the switch. Settings include:
•
•
LLDP-MED: SW Enables and disables Link Layer Discovery
Port Protocol Media Endpoint Discovery
(LLDP-MED) on the switch port. Use this setting
to force the phone to use a specific discovery
protocol, which should match the protocol
supported by the switch. Settings include:
•
•
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
4-44
Enable CDP on the switch port for VLAN
assignment for the phone, power negotiation,
QoS management, and 802.1x security.
Enable CDP on the switch port when the
phone is connected to a Cisco switch.
When CDP is disabled in Cisco Unified
Communications Manager, a warning is
presented, indicating that CDP should be
disabled on the switch port only if the
phone is connected to a non-Cisco switch.
The current PC and switch port CDP
values are shown on the Settings menu.
Enabled—default
Disabled
Enabled—default
Disabled
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified
Communications Manager
Administration, choose
Device > Phone.
From Cisco Unified
Communications Manager
Administration, choose
Device > Phone >
Phone Configuration
From Cisco Unified
Communications Manager
Administration, choose
Device > Phone >
Phone Configuration
OL-14620-01