1/4-Inch Device Removal - NEC PowerMate V486 Series Service Manual

5 1/4-Inch Device Removal

Use the following procedure to remove a 5 1/4-inch device from the 5 1/4-inch device
cage.
1. Remove the top cover, front panel, and 3 1/2-inch drive bracket as previously de-
scribed.
2. Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage.
3. Remove the four device screws; two from each side of the 5 1/4-inch device cage
(see Figure Section 5-13).
Remove the device out of the 5 1/4-inch device cage from the front of the system
4.
unit.
NOTE: When reinstalling the 5 1/4-inch device,
note that all power cables are keyed to fit only in
the correct position. The position of the red edge
of the diskette drive signal cable is shown in
Section 3, Options.
Figure Section 5-13 5 1/4-Inch Device Screws
Desktop Repair 5-13