1/4-Inch Device Removal - NEC POWERMATE VE - SERVICE MANUAL 05-1996 Service Manual

5-10 System Unit Repair

5 1/4-Inch Device Removal

Remove an 5 1/4-inch device from the 5 1/4-inch device cage per Figure Section 5-21, and
the following steps.
1. Remove the system unit cover, front panel, and 3 1/2-inch drive bracket as
previously described.
2. Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage (see Figure Section 5-21).
3. Remove the four device screws; two from each side of the 5 1/4-inch device cage
(see Figure Section 5-21).
Remove the device out of the 5 1/4-inch device cage from the front of the
4.
system unit.
NOTE: When reinstalling the 5 1/4-inch device,
note that all power cables are keyed to fit only in
the correct position.
Figure Section 5-21 5 1/4-Inch Device Screws
Power and Signal
Cables (not shown)
Two of Four
Screws