Figure 3-55 Lacp - Aggregation Port - SMC Networks 8708L2 - annexe 1 Management Manual

• Port Priority – If a link goes down, LACP port priority is used to select
a backup link. (Range: 0-65535; Default: 32768)
Set Port Partner – This menu sets the remote side of an aggregate link; i.e.,
the ports on the attached device. The command attributes have the same
meaning as those used for the port actor. However, configuring LACP
settings for the partner only applies to its administrative state, not its
operational state, and will only take effect the next time an aggregate link is
established with the partner.
Web – Click Port, LACP, Aggregation Port. Set the System Priority, Admin
Key, and Port Priority for the Port Actor. You can optionally configure
these settings for the Port Partner. (Be aware that these settings only affect
the administrative state of the partner, and will not take effect until the
next time an aggregate link is formed with this device.) After you have
completed setting the port LACP parameters, click Apply.

Figure 3-55 LACP - Aggregation Port

P C
ORT ONFIGURATION
3-133