Table of Contents
Advertisement
C
L
OMMAND
INE
Command
show access-list
ip
mask-precedence
ip access-group
show ip
access-group
map access-list ip Sets the CoS value and corresponding
show map
access-list ip
match access-list
ip
show marking
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the source
IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
4-120
I
NTERFACE
Table 4-34 IP ACL Commands (Continued)
Function
Shows the ingress or egress rule masks for
IP ACLs
Adds a port to an IP ACL
Shows port assignments for IP ACLs
output queue for packets matching an
ACL rule
Shows CoS value mapped to an access list
for an interface
Changes the 802.1p priority, IP
Precedence, or DSCP Priority of a frame
matching the defined rule (i.e., also called
packet marking)
Displays the current configuration for
packet marking
Mode
Page
PE
4-131
IC
4-132
PE
4-132
IC
4-133
PE
4-134
IC
4-135
PE
4-136
Advertisement
Table of Contents
