Configuring E-Mail Alerts - Dell IDRAC6 User Manual

3 Configure your PET policy.
At the command prompt, type the following command
and press <Enter>:
iPv4:racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertDestIPAddr -i 1 <IPv4_address>
iPv6:racadm config -g cfgIpmiPetIpv6 -o
cfgIpmiPetIPv6AlertDestIPAddr -i 1 <IPv6_address>
where 1 is the PET destination index and <IPv4_address> and
<IPv6_address> are the destination IP addresses of the system that
receives the platform event alerts.
4 Configure the Community Name string.
At the command prompt, type:
racadm config -g cfgIpmiLan -o
cfgIpmiPetCommunityName <Name>

Configuring E-Mail Alerts

Configuring E-mail Alerts Using the Web User Interface
For detailed information, see "Configuring E-Mail Alerts" on page 60.
Configuring E-Mail Alerts Using the RACADM CLI
1 Enable your global alerts.
Open a command prompt, type the following command,
and press <Enter>:
racadm config -g cfgIpmiLan -o
cfgIpmiLanAlertEnable 1
2 Enable e-mail alerts.
At the command prompt, type the following commands and
press <Enter> after each command:
racadm config -g cfgEmailAlert -o
cfgEmailAlertEnable -i 1 1
320
Monitoring and Alert Management