Dell IDRAC6 User Manual page 251

racadm config -g cfgIpmiSol -o cfgIpmiSolEnable 1
Update the IPMI SOL minimum privilege level.
a
NOTE:
The IPMI SOL minimum privilege level determines the minimum
privilege required to activate IPMI SOL. For more information, see the IPMI 2.0
specification.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiSol -o
cfgIpmiSolMinPrivilege <level>
where <level> is one of the following:
• 2 (User)
• 3 (Operator)
• 4 (Administrator)
For example, to configure the IPMI privileges to 2 (User), type the
following command:
racadm config -g cfgIpmiSol -o
cfgIpmiSolMinPrivilege 2
Update the IPMI SOL baud rate.
b
NOTE:
To redirect the serial console over LAN, ensure that the SOL baud rate
is identical to your managed system's baud rate.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiSol -o
cfgIpmiSolBaudRate <baud_rate>
where <baud_rate> is 9600, 19200, 57600, or 115200 bps.
For example:
racadm config -g cfgIpmiSol -o
cfgIpmiSolBaudRate 57600
Enable SOL for an individual user.
c
Configuring Intelligent Platform Management Interface
251