Configuring Ipmi Using Web Interface - Dell IDRAC6 User Manual

3 Click System Alerts Email Alert Settings.
4 In the Destination Email Addresses table, do the following to configure a
destination address for the Email Alert Number:
Select or clear the State checkbox. A selected checkbox indicates that
a
the email address is enabled to receive the alerts. A clear checkbox
indicates that the email address is disabled for receiving alert
messages.
In the Destination E-mail Address field, type a valid e-mail address.
b
In the E-mail Description field, type a short description.
c
5 In Test Email, click Send to test the configured e-mail alert settings.
6 In the SMTP (e-mail) Server IP Address field, enter a valid SMTP IP
address.
NOTE:
IP Address must be configured on the Email Alert Settings page. The SMTP
Server uses the set IP address to communicate with the iDRAC6 to send
e-mail alerts when a platform event occurs.
7 Click Apply. The settings are saved.

Configuring IPMI Using Web Interface

1 Log in to the remote system using a supported Web browser.
2 Configure IPMI over LAN.
In the System tree, click Remote Access.
a
Click the Network/Security tab and click Network.
b
In the Network page under IPMI Settings, select Enable IPMI Over
c
LAN and click Apply.
Update the IPMI LAN channel privileges, if required.
d
NOTE:
from the IPMI over LAN interface. For more information, see the IPMI 2.0
specifications.
Under IPMI Settings, click the Channel Privilege Level Limit drop-
down menu, select Administrator, Operator, or User and click Apply.
Set the IPMI LAN channel encryption key, if required.
e
NOTE:
To successfully send a test e-mail, the SMTP (email) Server
This setting determines the IPMI commands that can be executed
iDRAC6 IPMI supports the RMCP+ protocol.
Configuring the iDRAC6 Using the Web Interface
61