Dell IDRAC6 User Manual page 52

Table 4-3. Common Settings
Setting
DNS Domain
Name
Table 4-4. IPv4 Settings
Setting
Enable IPv4
DHCP Enable
IP Address
Subnet Mask
Gateway
Use DHCP to
obtain DNS server
addresses
Preferred DNS
Server
Alternate DNS
Server
52
Configuring the iDRAC6 Using the Web Interface
(continued)
Description
The default DNS Domain Name is blank. When the Auto
Config Domain Name checkbox is selected, this option is
disabled.
Description
If NIC is enabled, this selects IPv4 protocol support and sets
the other fields in this section to be enabled.
Prompts the iDRAC6 to obtain an IP address for the NIC from
the Dynamic Host Configuration Protocol (DHCP) server.
The default is off.
Specifies the iDRAC6 NIC IP address.
Allows you to enter or edit a static IP address for the iDRAC6
NIC. To change this setting, deselect the Use DHCP
(For NIC IP Address) checkbox.
The address of a router or switch. The value is in the "dot
separated" format, such as 192.168.0.1.
Enable DHCP to obtain DNS server addresses by selecting the
Use DHCP to obtain DNS server addresses checkbox. When
not using DHCP to obtain the DNS server addresses, provide
the IP addresses in the Preferred DNS Server and Alternate
DNS Server fields.
The default is off.
NOTE:
When the Use DHCP to obtain DNS server addresses
checkbox is selected, IP addresses cannot be entered into the
Preferred DNS Server and Alternate DNS Server fields.
DNS Server IP address.
Alternate IP address.