Dell IDRAC6 User Manual page 313

Table 17-3. LAN User Configuration
Item
Auto–Discovery
(continued...)
Provisioning Server
Account Access
Account Privilege
Account User Name Press <Enter> to edit the user name and press <Esc> when
Enter Password
Confirm Password
• Failed to restore settings to default values - Timeout.
• Not able to send Reset command. Please try later- iDRAC is busy.
Description
Before adding your Dell system to the network and using the
auto–discovery feature, ensure that:
• Dynamic Host Configuration Protocol (DHCP)
server/Domain Name System (DNS) are configured.
• Provisioning Web services is installed, configured, and
registered.
This field is used to configure the provisioning server. The
provisioning server address can be a combination of IPv4
addresses or hostname and should not exceed 255 characters.
Each address should be separated by a comma.
If the auto-discovery feature is enabled, and after the
auto-discovery process completes successfully, user credentials
are retrieved from the configured provisioning server to allow
future remote provisioning.
For more information, see the Dell Lifecycle Controller User
Guide available on the Dell Support website at
support.dell.com/manuals.
Select Enabled to enable the administrator account. Select
Disabled to disable the administrator account or when
Auto-Discovery is enabled.
Select between Admin, User, Operator, and No Access.
you have finished. The default user name is root.
Type the new password for the administrator account. The
characters are not echoed on the display as you type them.
Retype the new password for the administrator account. If the
characters you enter do not match the characters you entered
in the Enter Password field, a message is displayed and you
must re-enter the password.
Using the iDRAC6 Configuration Utility
313