Configuring Microsoft Active Directory With Standard Schema Using Racadm - Dell IDRAC6 User Manual

Configuring Microsoft Active Directory With Standard Schema Using
RACADM
Use the following commands to configure the iDRAC Active Directory
Feature with Standard Schema using the RACADM CLI instead of the
Web-based interface.
1 Open a command prompt and type the following RACADM commands:
racadm config -g cfgActiveDirectory -o
cfgADEnable 1
racadm config -g cfgActiveDirectory -o cfgADType 2
racadm config -g cfgStandardSchema -i <index> -o
cfgSSADRoleGroupName <common name of the role
group>
racadm config -g cfgStandardSchema -i <index> -o
cfgSSADRoleGroupDomain <fully qualified domain
name>
racadm config -g cfgStandardSchema -i <index> -o
cfgSSADRoleGroupPrivilege <Bit Mask Number for
specific user permissions>
NOTE:
Guide
racadm config -g cfgActiveDirectory -o
cfgADDomainController1 <fully qualified domain name
or IP address of the domain controller>
racadm config -g cfgActiveDirectory -o
cfgADDomainController2 <fully qualified domain name
or IP address of the domain controller>
racadm config -g cfgActiveDirectory -o
cfgADDomainController3 <fully qualified domain name
or IP address of the domain controller>
NOTE:
Subject or Subject Alternative Name field of your domain controller certificate
if you have certificate validation enabled.
NOTE:
the domain. For example, enter
of
dell.com
174
Using the iDRAC6 Directory Service
For Bit Mask Number values, see the
available on the Dell Support website at support.dell.com/manuals.
The FQDN or IP address that you specify in this field should match the
Enter the FQDN of the domain controller,
.
iDRAC6 Administrator Reference
not
servername.dell.com
only the FQDN of
instead