Virtual Media Configuration - Dell IDRAC6 User Manual

Table 17-1. LAN Parameters
Item
DNS Servers from
DHCP
DNS Server 1
DNS Server 2
Advanced LAN
Configurations
Auto-Negotiate
LAN Speed Setting If Auto-Negotiate is set to Disabled, select between 10 Mbps
LAN Duplex Setting If Auto-Negotiate is set to Disabled, select between Half

Virtual Media Configuration

Virtual Media
Press <Enter> to select Detached, Attached, or Auto-Attached. When you
select Attached, the Virtual Media devices are attached to the USB bus,
making them available for use during Virtual Console sessions.
If you select Detached, users cannot access Virtual Media devices during
Virtual Console sessions.
NOTE:
To use a USB Flash Drive with the Virtual Media feature, the USB Flash
Drive Emulation Type must be set to Hard disk in the BIOS Setup Utility. The BIOS
Setup Utility is accessed by pressing <F2> during server start-up. If the USB Flash
Drive Emulation Type is set to Auto, the Flash Drive will appear as a floppy drive to
the system.
(continued)
Description
Select On to retrieve DNS server addresses from a DHCP
service on the network. Select Off to specify the DNS server
addresses below.
If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
If NIC Selection is set to Dedicated, select between Enabled
and Disabled.
When Enabled is selected, LAN Speed Setting and LAN
Duplex Setting are configured automatically.
and 100 Mbps.
Duplex and Full Duplex.
Using the iDRAC6 Configuration Utility
307