Configuring Platform Event Filters (Pef); Configuring Platform Event Traps (Pet) - Dell IDRAC6 User Manual

Configuring Platform Event Filters (PEF)

NOTE:
Configure platform event filters before you configure the platform event
traps or e-mail alert settings.
1 Log in to the remote system using a supported Web browser.
See "Accessing the Web Interface" on page 46.
2 Click SystemAlertsPlatform Events.
3 Under Platform Event Filters Configuration, select the Enabled option
to Enable Platform Event Filter Alerts.
NOTE:
sent to any valid, configured destination (PET or e-mail).
4 In the Platform Event Filters List table, do the following for the filter(s)
that you want to configure:
• Select one of the following actions:
• Reboot System
• Power Cycle System
• Power Off System
• No Action
• In the Generate Alert column, select the checkbox to enable alert
generation or clear the checkbox to disable alert generation for the
selected action.
NOTE:
configured destination (PET).
5 Click Apply. The settings are saved.

Configuring Platform Event Traps (PET)

NOTE:
You must have Configure iDRAC permission to add or enable/disable an
SNMP alert. The following options will not be available if you do not have
Configure iDRAC permission.
1 Log in to the remote system using a supported Web browser.
2 Ensure that you have performed the procedures in "Configuring Platform
Event Filters (PEF)" on page 59.
3 Click SystemAlertsTraps Settings.
Enable Platform Event Filter Alerts must be enabled for an alert to be
Generate Alert must be enabled for an alert to be sent to any valid,
Configuring the iDRAC6 Using the Web Interface
59