Dell IDRAC6 User Manual page 252

NOTE:
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgUserAdmin -o
cfgUserAdminSolEnable -i <id> 2
where <id> is the user's unique ID.
4 Configure IPMI Serial.
Change the IPMI serial connection mode to the appropriate setting.
a
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgSerial -o
cfgSerialConsoleEnable 0
Set the IPMI Serial baud rate.
b
Open a command prompt, type the following command, and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate <baud_rate>
where <baud_rate> is 9600, 19200, 57600, or 115200 bps.
For example:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate 57600
Enable the IPMI serial hardware flow control.
c
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialFlowControl 1
252
Configuring Intelligent Platform Management Interface
SOL can be enabled or disabled for each individual user.