Dell IDRAC6 User Manual page 250

Open a command prompt, type the following command, and press
<Enter>:
racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
NOTE:
from the IPMI over LAN interface. For more information, see the IPMI 2.0
specifications.
Update the IPMI channel privileges.
a
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit <level>
where <level> is one of the following:
• 2 (User)
• 3 (Operator)
• 4 (Administrator)
For example, to set the IPMI LAN channel privilege to 2 (User), type
the following command:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit 2
Set the IPMI LAN channel encryption key, if required.
b
NOTE:
specifications for more information.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiLan -o
cfgIpmiEncryptionKey <key>
where <key> is a 20-character encryption key in a valid
hexadecimal format.
3 Configure IPMI Serial over LAN (SOL).
At the command prompt, type the following command and press
<Enter>:
250
Configuring Intelligent Platform Management Interface
This setting determines the IPMI commands that can be executed
The iDRAC6 IPMI supports the RMCP+ protocol. See the IPMI 2.0