Enabling And Disabling The Racadm Remote Capability; Racadm Subcommands - Dell IDRAC6 User Manual

Table 5-14. racadm Command Options
Option
-S
Enabling and Disabling the RACADM Remote
Capability
NOTE:
It is recommended that you run these commands on your local system.
The remote capability is enabled by default. If disabled, type the
RACADM
following
RACADM
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 1
To disable the remote capability, type:
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 0

RACADM Subcommands

Table 5-15 provides a description of each RACADM subcommand that you
can run in RACADM. For a detailed listing of RACADM subcommands,
including syntax and valid entries, see the iDRAC6 Administrator Reference
Guide available on the Dell Support website at support.dell.com/manuals.
When entering a RACADM subcommand, prefix the command with
racadm, for example:
racadm help
114
Advanced iDRAC6 Configuration
(continued)
Description
Specifies that RACADM should check for invalid
certificate errors. RACADM stops the execution of the
command with an error message if it detects an invalid
certificate.
command to enable: