Viewing Internal Dual Sd Module Status Using Gui - Dell IDRAC6 User Manual

Table 4-31. IDSDM Status
IDSDM - Mirror
Mode
Enabled
Disabled
Using iDRAC you can view the status, health, and availability of IDSDM.
The SD card redundancy status and failure events are logged to SEL,
displayed on LCD, and PET alerts are generated if alerts are enabled.

Viewing Internal Dual SD Module Status Using GUI

1 Log in to the iDRAC Web GUI.
2 Click Removable Flash Media. The Removable vFlash Media page is
displayed. This page displays the following two sections:
Internal Dual SD Module — Displayed only if IDSDM is in redundant
•
mode. The Redundancy Status is displayed as Full. If this section is not
present, then the card is in the non-redundant mode state. The valid
Redundancy Status indications are:
Full — SD card 1 and 2 are functioning properly.
–
– Lost — Either one of the SD card or both the SD cards are not
functioning properly.
Internal SD Module Status — Displays the SD card state for SD1, SD2,
•
and vFlash cards with the following information:
– Status:
•
•
•
– Location — Location of the SD cards.
– Online Status — SD1, SD2, and vFlash cards can be in one of the
states listed in Table 4-32.
SD1 Card
Active
Active
— Indicates that the card is ok.
— Indicates that the card is offline or write-protected.
— Indicates that an alert is issued.
Configuring the iDRAC6 Using the Web Interface
SD2 Card
Active
Inactive
vFlash SD Card
Inactive
Active
85