Danfoss VLT FC 280 Operating Manual page 55

Operating Guide | VLT® Midi Drive FC 280
To avoid unintentional overwriting of the data in the memory module, consider to adjust the settings for parameter 31-40
Memory Module Function before next power cycle according to different operating purpose.
1.
Plug a new empty memory module in the drive.
2. Select [2] Only Allow Upload or [3] Allow Both Download and Upload in parameter 31-40 Memory Module Function.
3.
Power up the drive.
4.
Wait until the synchronization is complete, refer to
on the drive.
Copying Data to Another Drive
5.10.3
Prerequisite:
To avoid unintentional overwriting of the data in the memory module, consider to adjust the settings for parameter 31-40
Memory Module Function before next power cycle according to different operating purpose.
1. Make sure that the required data is uploaded to the memory module, refer to
Module (Create Drive
2.
Unplug the memory module and plug into a new drive.
3. Make sure that [1] Only Allow Download or [3] Allow Both Download and Upload is selected in parameter 31-40 Memory
Module Function on the new drive.
4. Power up the new drive.
5. Wait until the download is complete and the data is transferred, refer to
transfer indications on the drive.
Copying Data to Multiple Drives
5.10.4
If multiple drives are of same voltage/power, the information of 1 drive can be transferred to the others via 1 memory module.
The data can also be downloaded to the memory module from a PC via the VLT® Memory Module Programmer.
In any of the drives, if an empty memory module is plugged in for backing up data, adjust the settings for parameter 31-40
Memory Module Function to [2] Only Allow Upload or [3] Allow Both Download and Upload before next power cycle.
1. Follow the steps in
5.10.2 Synchronizing Drive Data to a New Memory Module (Create Drive Backup)
drive to a memory module.
2.
To avoid unintentional uploading of data to the master memory module, make sure that [1] Only Allow Download is selected in
parameter 31-40 Memory Module Function on the other drives.
3.
Unplug the memory module and plug it into a new drive.
4. Power up the new drive.
5. Wait until the download is complete and the data is transferred, refer to
transfer indications on the drive.
6. Repeat steps 3–5 for the next drive.
Danfoss A/S © 2024.10
Backup).
NOTICE
5.10.8 Transfer Performance and Indications
NOTICE
5.10.2 Synchronizing Drive Data to a New Memory
5.10.8 Transfer Performance and Indications
NOTICE
NOTICE
5.10.8 Transfer Performance and Indications
Commissioning
to check the transfer indications
to check the
to upload the data from 1
to check the
AQ381425076031en-000201 / 130R1223 | 55